Nvidia 680I LT SLI Manuel d'utilisateur télécharger pdf (Page 68)

Mainboard nForce 680i SLI/

Mainboard nForce 680i LT SLI

Rebuilding a RAID Mirrored Array

This section will illustrate how to replace a failed drive with a new one, and rebuild the array

to restore lost data on the newly installed drive. Rebuilding only applies to fault-tolerant

arrays which are RAID 1, RAID 0+1, and RAID 5 arrays.

1. Before rebuilding an array, you must connect new hard disk(s) onto your computer.

2. Power on your computer. When the system boots up during the POST (Power-On Self

Test), you will be given an opportunity to enter the NVIDIA RAID Setup Utility when the

screen prompts you with the following message.

“Press F10 to enter RAID setup utility…”

3. Press <F10> key to enter the NVIDIA RAID Setup Utility (note that you will only have a

short window of time to press <F10> before the system continues the next step of the boot

process).

4. Go to the screen shown as below. Press <Enter>.

1 2 ... 63 64 65 66 67 68 69 70 71 72 73 ... 79 80

Pas de commentaire

Nvidia 680I LT SLI Manuel d'utilisateur Page 68