Nvidia N61S Manuel d'utilisateur télécharger pdf (Page 9)

- 8 -

nVIDIA N61P/N61S/N61V User's /Manual

Chapter 2 Hardware Setup

2.1 Choosing a Computer Chassis

• Choose a chassis big enough to install this mainboard.

• As some features for this mainboard are implemented by cabling connectors on the

mainboard to indicators and switches or buttons on the chassis, make sure your chassis

supports all the features required.

• If there is possibility of adopting some more hard drives, make sure your chassis has

sufcient power and space for them.

• Most chassis have alternatives for I/O shield located at the rear panel. Make sure the I/O

shield of the chassis matches the I/O port conguration of this mainboard. You can nd

an I/O shield specically designed for this mainboard in its package.

2.2 Installing Mainboard

Most computer chassis have a base with many mounting holes to allow the mainboard to

be securely attached, and at the same time, prevent the system from short circuits. There

are two ways to attach the mainboard to the

chassis base: (1) with studs, or (2) with spacers.

Basically, the best way to attach the board is with

studs. Only if you are unable to do this should you

attach the board with spacers. Line up the holes on

the board with the mounting holes on the chassis.

If the holes line up and there are screw holes, you

can attach the board with studs. If the holes line

up and there are only slots, you can only attach with

spacers. Take the tip of the spacers and insert them

into the slots. After doing this to all the slots, you can slide the board into position aligned

with slots. After the board has been positioned, check to make sure everything is OK before

putting the chassis back on.

To install this mainboard:

1. Locate all the screw holes on the mainboard and the chassis base.

2. Place all the studs or spacers needed on the chassis base and have them tightened.

3. Face the mainboard’s I/O ports toward the chassis’s rear panel.

4. Line up all the mainboard’s screw holes with those studs or spacers on the chassis.

5. Install the mainboard with screws and have them tightened.

The mainboard and its component layouts illustrated in this chapter were

based mainly on model “nVIDIA N61(V1.0)”, unless speci cally stated.

Always power off the computer and unplug the AC power cord before adding or removing

any peripheral or component. Failing to do so may cause severe damage to your

mainboard and/or peripherals. Plug in the AC power cord only after you have carefully

checked everything.

To prevent shorting the PCB circuit, please REMOVE the metal studs or spacers if they are

already fastened on the chassis base and are without mounting-holes on the mainboard to

align with.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 36 37

Commentaires sur ces manuels

Pas de commentaire

Nvidia N61S Manuel d'utilisateur Page 9

Commentaires sur ces manuels

Produits connexes et manuels pour Matériel Nvidia N61S